jennin64

已修正如下，有問題請提出或自行再修正。

Replacing the emergency stop button for with one can rotate to restore type of switch. can be turned to reset.
 
The pressure of the sources of cooling pipes has 6KG, so ask the end of the customer to be  installed the a valve in the pipeline to reduce it. 
 
(此句之中文意思應再清楚些，究是調要調降或調升水壓力?)

Hot The heating water equipment should adjust the 2.6 KG water pressure, and the input cooling water had to adjust 2.8 KG water pressure.

Because of  the function of blowing affected by  the upward shape of recovery the recycling pipe up, the  air pressure regulator in the gantry should be adjusted to be 2KG and then it'll be enough able to push the water in the jacket back to the  recovery recycling pipe. If the pressure of the jacket is stronger than the pressure of the blowing function, the water will surge out of the regulator, so when designing the pipe should reconsider how to avoid the water flow back.
 
 Because the temperature of the cooling water is 6 degrees, the parts of many cooling pipes which are not wrapped with thermal insulation will dew, especially the whole slice of vacuum condensate tank .
 
主槽溫度到時餘溫會高至42℃左右(此句之中文文意，我認為應是”當熱水裝置目標溫度到達後，主槽之餘溫會高至42度C)。Heating test set via the goal temperature of the main tank to 40 degrees , and set the temperature of the hot heating water device 40℃ and to 45℃ of to operate, the  residual heat of main tank  will be as higher as to about 42℃ around as when the heating water device’s the  temperature of main tank reaches the goal. Depending on this situation, the customers will consider setting the heating water device’s goal temperature to determine the main tank’s final heat. For example, the main tank is set to 40℃  as its goal temperature, and before the tank’s temperature surges up to 38℃, the heating water device is set to 50℃ for heating, when the temperature of the main tank is over 38℃, the hot heating water heating device is set to 43℃ to heat to prevent the residual heat of the main tank from being too high.